Hi,
I am now on the #124 DOS build and I was wondering if anyone has a chassis drilling diagram/drawing. I bought a blank Al chassis and faceplates from tube-town.de and now the hard part comes. Sure, I can roughly place the components, but I was wondering whether there's an established and tested configuration.
Thanks
I've managed to drill and cut the chassis by hand with a little help from Andrea. I could add a PDF that I edited and loosely worked from if it helps? I just printed it to the size of the chassis, stuck it on and marked any centres that worked for me and moved some things around that didn't for a better fit. I'm building the 183 so will be slightly different but gives you a good idea of what goes where. The TT faceplates didn't fill me with confidence as some things (rear side) seemed to be in different locations, I got a rough template that was being passed around on Amp Garage and just edited the file and had them printed for a reasonable cost.