Sounds great, I will try to capture some recordings. Board build went better than I thought. Very few problems after soldering and wiring board. The opto isolator spacing is real tight. A genuine Fender Roach has more access to leads. Also the cap for the bias is difficult to source. I have used 25 and 50 volt 25 ohm caps in other Fender builds. Is there a design reason for doing this? I really like the way you moved the filer caps to the board from the doghouse. 😁

Look at Ted Weber speaker amp kits. They sell a 6A80 chassis with brass plates and faceplates. I like their chassis because they have a copper clad grounding lug by the Power Transformer plus the brass shielding plate for the control panel.

I found that the Genuine Fender Roach worked much better than the copies. It was not sealed as much so you could trim some of the shrink wrap around the legs and wrap them individually. This worked out much better. The price if you shopped it is about the same if you shop it.

I am building a Fender Deluxe Reverb using a Fender Board. I have the BOM but it does list a mode just optoisolator. Does this board use a Fender Style Roach optoisolator?. I have a replacement for a Fender Deluxe Reverb and it seems much larger. Has anybody used a Vishay chip type with 4 leads?